Detecting pore size distribution of activated carbon by low-field nuclear magnetic resonance

In this study, the transverse relaxation time (T₂) of activated carbon (AC) in different relative environment humidity was detected firstly by low-field nuclear magnetic resonance (LFNMR). The pore size (diameter) of AC distributions was calculated by the relationship between T₂ and surface relaxation rate (ρ), where ρ was obtained by the detection of nine porous materials with known pore size. The results showed that the pore size distributions of AC calculated by ρ < 0.19 nm/ms were in good agreement with that obtained by nitrogen adsorption method and proved that LFNMR as a new detection method was feasible for characterizing AC pore size distribution.     

动态激光衍射法测量细丝直径

基于夫琅禾费衍射理论和巴比涅互补原理,提出了利用激光衍射对细丝直径进行动态测量的方法.该方法具有测量精度高、速度快、非接触、使用方便且易于微机联接实现自动化测量等优点.     

直径对脉冲爆震发动机性能的影响

本文通过实验研究了脉冲爆震发动机的直径对其性能的影响．实验结果表明；当爆震室的直径增大时，爆震波压力波形相似，平均峰值压力比较接近，且比冲基本保持不变，而推力则随爆震室直径的增大而增大。实验曲线表明爆震室内的流动具有自相似性，从而为建立尺寸律提供了实验依据．本文中比冲和平均推力是利用摆动原理测量的，并与由作用在推力壁上的压力计算得出的比冲和平均推力的理论值和实验值进行了比较，结果基本吻合，说明该测量方法可行．     

用毛细管测量纯水表面张力系数的误差讨论

通过用毛细管测量纯水表面张力系数实验，得到管内径d与接触角θ的相对误差之间的关系曲线，由此说明实验测得的表面张力系数α和理论公式相比呈现一定的偏差，并简单地讨论了实验的理想状态与实际情况的差别．     

二次阳极氧化方法制备有序多孔氧化铝膜

通过二次阳极氧化方法制备多孔氧化铝膜与一次阳极氧化方法制备多孔氧化铝膜孔排布规律性的对比 ,结果发现 ,二次阳极氧化方法制取的多孔氧化铝膜孔排布规律性明显好于一次阳极氧化法制取的多孔膜 .在几个微米范围内 ,孔呈理想的六角排布 .去除一次阳极氧化膜后 ,二次阳极氧化得以在更良好的表面进行 ,制取的氧化铝膜孔规律性和有序度更高 .有序区域的尺寸与晶粒内的亚晶大小有一定关系     

大气气溶胶粒子光吸收系数的测量

 采用核孔过滤膜累积气溶胶粒子的方法设计了气溶胶粒子光吸收系数的测量系统。该系统由双光路组成,可以减小光路损耗和电路噪声带来的各种测量误差。同时，具有体积小、光路易于调节、可进行实时测量、定标容易等特点。用200和400nm孔径的过滤膜，分别测量了实验室内大气气溶胶粒子对不同波长激光的吸收系数。随着累积时间的增加，系统的测量精度也不断的提高，在累积时间为900s时，系统测量误差为9.849×10^-6/m。     

The Modeling of Velocity Enhancement in Polymer Flooding

In single-phase polymer flooding experiments it has repeatedly been observed that the average velocity of the polymer molecules is higher than the average velocity of the water molecules. This effect is incorporated in many conventional Enhanced Oil Recovery (EOR) simulators by the introduction of a constant velocity enhancement factor. In this paper we show that, in absence of dispersion, a constant enhancement factor in the mathematical model for two-phase polymer flow (Buckley--Leverett displacement) leads to ill-posedness of the model equations. We propose a saturation dependent enhancement factor, derived from a model based on percolation concepts, for which this problem does not occur.     

A new method for constructing infinite families of k-tight optimal double loop networks

The double loop network (DLN) is a circulant digraph with n nodes and outdegree 2. DLN has been widely used in the designing of local area networks and distributed systems. In this paper, a new method for constructing infinite families of k-tight optimal DLN is presented. For k = 0,1,…,40, the infinite families of k-tight optimal DLN can be constructed by the new method, where the number nk(t,a) of their nodes is a polynomial of degree 2 in t and contains a parameter a. And a conjecture is proposed.     

Standardization of Methods for Characterizing the Surface Geometry of Solids

Since a comprehensive survey published in 1999 [1] much work was done in standardizing measuring methods to characterize the surface geometry of dispersed and/or porous solids and to certify reference materials. The present paper is an extension of a short communication [2]. It gives a survey on existing standards and reports on new drafts and proposals.